Is St. George, UT Tap Water Safe to Drink?
Yes, St. George tap water is safe to drink. No contaminants exceed health guidelines. However, St. George has very hard water at 266 PPM, which will cause scale buildup in plumbing and appliances over time. A water softener is worth considering.
Hardness Scale: Where St. George Falls
0Slightly
60Moderate
120Hard
180Very Hard
250Extreme
400+
How St. George Compares
St. George's water is 93% harder than the national average of 138 PPM. It ranks #131 out of 1000 cities in our database (harder than 87% of US cities we track). Within Utah, St. George has the 3rd hardest water out of 19 cities - 10% above the state average of 241 PPM. Among mid-size cities (100k-200k), St. George ranks #20 of 189 for hardness. At this hardness level, water heaters run an estimated 49% less efficiently due to scale insulation, and major water-using appliances typically last 4 years less than the national average lifespan.
What St. George's Water Means for Your Home
Hardness: 266 PPM - Treatment Recommended
St. George has some extremely hard water. At 266 PPM (15.6 grains per gallon), your tap is loaded with mineral content carried in from the watershed geology. Here's the thing: it's perfectly safe to drink. The minerals won't hurt you. But they will hurt your wallet. That adds up. Hard water at 266 PPM increases household costs through scale-coated water heaters that use more energy, extra soap and detergent, and appliances that wear out faster. Most St. George homeowners don't realize it until the plumber shows up. That's 10% harder than the Utah average.
Contaminants & Safety
Disinfection byproducts are the notable finding here. St. George's water has TTHMs at 35.4 ppb and HAA5 at 9.27 ppb — both within legal limits, but the EWG health guidelines are far stricter. These byproducts form when chlorine reacts with organic matter during treatment. A whole-house activated carbon filter reduces both chlorine and its byproducts. Want the full picture? Request your utility's annual Consumer Confidence Report.
What's in the Treatment Process
St. George's surface water supply requires heavy chlorination to stay safe — but that creates a tradeoff. The treatment process generates disinfection byproducts: TTHMs at 35.4 ppb (44% of the legal limit, but 236x the EWG guideline) and HAA5 at 9.27 ppb (15% of the legal limit, but 93x the EWG guideline). These are within legal limits, but the EWG sets much tighter thresholds based on cancer-risk research. A whole-house activated carbon filter reduces both chlorine and byproducts.
Chromium-6 was detected at 0.279 ppb, which is 14x the EWG health guideline. There's no separate federal limit for chromium-6, only total chromium. A reverse osmosis system is the most effective removal method. All measurements are within federal legal limits. The EWG guidelines represent a more conservative, health-based standard.
How Hard Water Affects Your Home
At 266 PPM, untreated hard water has measurable effects on household costs and appliance life:
- Water heater inefficiency: Scale insulation forces the heater to work harder (DOE estimates up to 22% more energy for heavily scaled units)
- Soap and detergent: Hard water reduces lathering, requiring significantly more product
- Appliance replacement: Water heaters, dishwashers, and washing machines fail 2-4 years earlier due to scale buildup
- Plumbing maintenance: Scale buildup in pipes reduces flow and requires more frequent service
Note: Impact varies by household size, water usage, and local energy costs. A home water test provides the most accurate assessment for your specific situation.
| Contaminant | Detected | Health Guideline | Legal Limit | Status |
|---|---|---|---|---|
| Hardness (as CaCO₃) | 266 PPM | < 60 PPM | No federal limit | ⚠ Very Hard |
| Total Dissolved Solids | 447 PPM | < 300 PPM | 500 PPM | ⚠ Elevated |
| PFAS (total) | 0 ppt | — | No total limit | ✓ ND |
| ↳ PFOA | 0 ppt | 0 ppt | 4 ppt (2024) | ✓ OK |
| ↳ PFOS | 0 ppt | 0 ppt | 4 ppt (2024) | ✓ OK |
| Lead | 1.4 ppb | 0 ppb (no safe level) | 15 ppb (10 ppb in 2027) | ✓ Low |
| Chlorine / Chloramine | 1.1 mg/L | Taste threshold ~1.0 | 4.0 mg/L | ✓ Normal |
| Nitrate | 0.431 mg/L | 5 mg/L | 10 mg/L | ✓ OK |
Our Top Picks for St. George (266 PPM)
Hard water at 266 PPM causes scale buildup, increased energy use, and premature appliance failure. A softener protects your plumbing and appliances.
Quick Fix for Chlorine: Shower Filter
At 1.1 mg/L chlorine, many St. George residents notice dry skin, brittle hair, and that "pool smell" in the shower. A shower filter installs in 5 minutes, no tools needed.
How to Test Your Water in St. George
With 266 PPM hardness, a quick test strip confirms whether your specific tap matches St. George's average before you invest in a softener. Hardness can vary within the same system.
Free option: Request Washington County Water's annual Consumer Confidence Report for official city-level data.
📊 Already Tested Your Water?
City averages miss neighborhood-level variation. Share your results to help your neighbors get better data.
We review every submission before publishing. Your ZIP is shown; your identity is not.
About St. George's Water Supply
Water Utility: Washington County Water
Water Source: Quail Creek Reservoir, Sand Hollow (Surface Water)
Population Served: 105,240
Hardness: 266 PPM (15.6 grains per gallon)
St. George's drinking water comes from surface sources — Quail Creek Reservoir, Sand Hollow. Surface water requires more extensive treatment than groundwater, including coagulation, filtration, and disinfection. This heavier chlorination is why disinfection byproducts tend to be higher in surface-supplied systems. Despite the treatment process, mineral hardness from the watershed carries through. The system serves 105,000 residents.
Water quality can vary by neighborhood and season. For your exact numbers, request Washington County Water's Consumer Confidence Report (CCR) or test your own tap.
ZIP Codes Covered by This Report
This water quality data applies to all areas served by Washington County Water in St. George, UT, including ZIP codes:
84710, 84712, 84713, 84714, 84716, 84718, 84719, 84720, 84721, 84722, 84723, 84725, 84726, 84728, 84729, 84731, 84733, 84735, 84736, 84737, 84738, 84740, 84741, 84742, 84743, 84745, 84746, 84750, 84751, 84752, 84753, 84755, 84756, 84757, 84758, 84759, 84760, 84761, 84762, 84763, 84764, 84765, 84767, 84770, 84771, 84772, 84774, 84776, 84779, 84780, 84781, 84782, 84783, 84784, 84790, 84791, 86021, 86022, 86036, 86040, 86432, 86435, 89007, 89008, 89024, 89027, 89034, 89042, 89043, 89301, 89311, 89314, 89317, 89319
If your ZIP code is listed above, this report covers your water supply. Water quality may vary slightly by neighborhood.
Water Softener Sizing for St. George
At 266 PPM (15.6 GPG), here is how to size a softener for your St. George home. Multiply hardness in GPG (15.6) by daily water usage (roughly 50 gallons per person). A family of four uses about 200 gallons/day: 15.6 GPG × 200 gal = 3120 grains/day. Over a 7-day regeneration cycle, that is 21,840 grains - a 32,000-grain softener is the right fit for most St. George households.
Compare St. George to Other Utah Cities
Frequently Asked Questions About St. George Water
Is St. George tap water safe to drink?
Where does St. George's water come from?
Do I need a water softener in St. George?
Does St. George water damage tankless water heaters?
How much does hard water cost a St. George household per year?
What is the hardness of St. George water in grains per gallon?
What size water softener do I need for St. George?
Salt-based softener or salt-free conditioner for St. George?
Data sources: Lead and copper data from EPA Safe Drinking Water Act LCR reporting. Contaminant data from utility-reported testing results. PFAS data from EPA UCMR5 (2023–2025). Hardness from USGS and municipal reports. Data reflects system-level testing results and may not match your specific tap due to neighborhood plumbing, season, or recent utility changes. For your utility's latest results, request their Consumer Confidence Report (CCR). Our methodology. Last updated: 2026-02-24.
What St. George Homeowners Actually Buy
Common purchases for homes with 266 PPM water.
Affiliate disclosure: we may earn a commission. Selection based on St. George's water data.