Is Silverton, OR Tap Water Safe to Drink?

A
ExcellentNo concerns detected

Yes, Silverton tap water is safe to drink. Hardness is low at 25 PPM, and no contaminants exceed health guidelines. Most homes here don't need treatment.

City of Silverton Water · Source: Silver Creek & Abiqua Creek · Serves 10,484 residents ·

25
Hardness (PPM)
25
OR Average
138
National Avg
0
PFAS (ppt)
9.1
Lead (ppb)
25 PPM Slightly Hard
CONTAMINANT LEVELS Hardness 25 PPM TDS 38 PPM PFAS 0 ppt Lead 9.1 ppb Chlorine 0.6 mg/L Nitrate 0.272 mg/L
Water hardness gauge for Silverton OR showing 25 PPM Slightly HardWater quality contaminant levels in Silverton OR compared to EPA limits - hardness 25 PPM, PFAS 0 ppt, lead 9.1 ppb

Hardness Scale: Where Silverton Falls

Soft
0
Slightly
60
Moderate
120
Hard
180
Very Hard
250
Extreme
400+
Elevated lead levels

How Silverton Compares

Silverton's water is 82% softer than the national average of 138 PPM - ranking in the bottom 88% for hardness nationwide. Most homes here do not need a softener. Within Oregon, it ranks #20 of 48 cities (0% below the state average of 25 PPM). Among smaller cities, Silverton ranks #237 of 288 for hardness.

What Silverton's Water Means for Your Home

Hardness: 25 PPM - Low Concern

Silverton's water is slightly hard at 25 PPM. Most households won't notice any issues at this level. Scale buildup is minimal, and a water softener would be overkill. Silverton is softer than 88% of US cities. If you're thinking about water treatment, contaminant filtration is where to focus your money, not softening.

Contaminants & Safety

Lead levels deserve attention. At 9.1 ppb, Silverton is above the ideal of zero, though below the EPA action level of 15 ppb (dropping to 10 ppb in November 2027 under the Lead and Copper Rule Improvements). The lead typically comes from aging service lines or interior plumbing, not the treatment plant. A point-of-use filter certified for lead at the kitchen faucet is a practical safeguard, especially in older homes.

What's in the Treatment Process

Silverton's surface water supply requires heavy chlorination to stay safe — but that creates a tradeoff. The treatment process generates disinfection byproducts: TTHMs at 8.84 ppb (11% of the legal limit, but 59x the EWG guideline) and HAA5 at 2.32 ppb (4% of the legal limit, but 23x the EWG guideline). These are within legal limits, but the EWG sets much tighter thresholds based on cancer-risk research. A whole-house activated carbon filter reduces both chlorine and byproducts. All measurements are within federal legal limits. The EWG guidelines represent a more conservative, health-based standard.

Water quality contaminant levels for Silverton, OR
ContaminantDetectedHealth GuidelineLegal LimitStatus
Hardness (as CaCO₃)25 PPM< 60 PPMNo federal limit✓ OK
Total Dissolved Solids38 PPM< 300 PPM500 PPM✓ OK
PFAS (total)0 pptNo total limit✓ ND
↳ PFOA0 ppt0 ppt4 ppt (2024)✓ OK
↳ PFOS0 ppt0 ppt4 ppt (2024)✓ OK
Lead9.1 ppb0 ppb (no safe level)15 ppb (10 ppb in 2027)⚠ Elevated
Chlorine / Chloramine0.6 mg/LTaste threshold ~1.04.0 mg/L✓ Normal
Nitrate0.272 mg/L5 mg/L10 mg/L✓ OK

How to Test Your Water in Silverton

Lead enters water from your home's plumbing, not the treatment plant — so Silverton's city-wide average of 9.1 ppb may not match your tap. Testing your specific faucet is the only way to know. Run cold water for 30 seconds before collecting a sample.

Most Accurate: Certified Lab Kit

Mail-in sample analyzed by a certified lab. 21+ parameters including PFAS, heavy metals, and bacteria. Worth it for confirming lead levels at your specific tap.

Tap Score Lab Kit
Quick Check: DIY Test Strips

Results in 60 seconds. Tests hardness, lead, chlorine, pH, and 13 other parameters. Good enough to confirm whether your home matches the city average.

Varify 17-in-1 Test Strips
Verify Your Filter: TDS Meter

Instant digital reading of total dissolved solids. Handy for checking if your filter is performing. Test before and after.

HoneForest TDS Meter

Free option: Request City of Silverton Water's annual Consumer Confidence Report for official city-level data.

📊 Already Tested Your Water?

City averages miss neighborhood-level variation. Share your results to help your neighbors get better data.

We review every submission before publishing. Your ZIP is shown; your identity is not.

About Silverton's Water Supply

Water Utility: City of Silverton Water

Water Source: Silver Creek & Abiqua Creek (Surface Water)

Population Served: 10,484

Hardness: 25 PPM (1.5 grains per gallon)

Silverton's drinking water comes from surface sources — Silver Creek & Abiqua Creek. Surface water requires more extensive treatment than groundwater, including coagulation, filtration, and disinfection. This heavier chlorination is why disinfection byproducts tend to be higher in surface-supplied systems. On the upside, surface sources often deliver softer water than deep aquifers. The system serves 10,000 residents.

Water quality can vary by neighborhood and season. For your exact numbers, request City of Silverton Water's Consumer Confidence Report (CCR) or test your own tap.

ZIP Codes Covered by This Report

This water quality data applies to all areas served by City of Silverton Water in Silverton, OR, including ZIP codes:

97362, 97373, 97375, 97381

If your ZIP code is listed above, this report covers your water supply. Water quality may vary slightly by neighborhood.

Compare Silverton to Other Oregon Cities

Frequently Asked Questions About Silverton Water

Is Silverton tap water safe to drink?
Yes, Silverton tap water is safe to drink. All regulated contaminants are within EPA limits. Review the contaminant table above for details.
Where does Silverton's water come from?
Silverton's drinking water is sourced from Silver Creek & Abiqua Creek and treated by City of Silverton Water. Surface water requires more extensive treatment, including chlorination, which can produce disinfection byproducts.
Do I need a water softener in Silverton?
At 25 PPM, Silverton's water is on the soft side. A water softener isn't needed. Focus on filtration if you have specific contaminant concerns.
What water filter is best for Silverton?
The best filter depends on which contaminants you want to address. For lead, look for NSF/ANSI Standard 53 certification at the kitchen faucet. See our softener vs. filter guide for the full breakdown.
Is Silverton water safe for babies and infants?
Caution is warranted for Silverton water and infant formula. Concerns: lead at 9.1 ppb (no safe level for children). Use filtered water (reverse osmosis or NSF-certified) or bottled water for formula preparation.
What are disinfection byproducts in Silverton's water?
Disinfection byproducts form when chlorine reacts with organic matter during water treatment. Silverton has TTHMs at 8.84 ppb and HAA5 at 2.32 ppb — within legal limits but above EWG health guidelines. A whole-house activated carbon filter reduces both chlorine and its byproducts.
Can I drink Silverton tap water straight from the faucet?
Silverton's water meets all EPA legal standards. Lead at 9.1 ppb is elevated. For drinking and cooking water, a point-of-use filter adds meaningful protection. Take our quiz to find the right solution.

Data sources: Lead and copper data from EPA Safe Drinking Water Act LCR reporting. Contaminant data from utility-reported testing results. PFAS data from EPA UCMR5 (2023–2025). Hardness from USGS and municipal reports. Data reflects system-level testing results and may not match your specific tap due to neighborhood plumbing, season, or recent utility changes. For your utility's latest results, request their Consumer Confidence Report (CCR). Our methodology. Last updated: 2026-02-24.

What Silverton Homeowners Actually Buy

Common purchases for homes with 25 PPM water.

Affiliate disclosure: we may earn a commission. Selection based on Silverton's water data.

On a private well? This report covers Silverton's municipal water only. Interpret your well water lab report

💧 What Does Your Water Need?

Get a personalized recommendation for Silverton in 60 seconds.

Take the Quiz →

🧪 Test Your Water at Home

City averages may not match your tap. Test for exact numbers.

How to test your water →