Is Sparks, NV Tap Water Safe to Drink?

C
Fair1 item found

EPA data shows a health concern for Sparks's water system. Specifically: PFOA/PFOS above EPA's 4 ppt standard at one or more entry points (PFOA 5.2 ppt, PFOS 13 ppt; EPA UCMR 5 testing, 2023 to 2025; the standard is enforceable from 2029). A point-of-use filter certified for the specific contaminant can reduce what you drink while the utility addresses it.

Truckee Meadows Water Authority (EPA ID NV0000190) · Source: Surface water · System serves 442,000 people

Data as of · EPA violations: as of October 14, 2026 · Lead: Jan 2023–Dec 2025 testing · PFAS & lithium: EPA UCMR 5, Jan 2023–Sep 2025 · Other contaminants: EWG Tap Water Database (data as of Feb 2026) · Hardness, TDS & chlorine: estimates

EPA health violations for Truckee Meadows Water Authority

No health-based violations (exceeding a contaminant or disinfectant limit, or missing a required treatment step) reported to EPA for Truckee Meadows Water Authority since November 2023.

Source: EPA Safe Drinking Water Information System (SDWIS) via ECHO, data as of October 14, 2026, EPA system ID NV0000190. Covers health-based violations since November 2023; monitoring and reporting violations are not shown. Look up the system on EPA ECHO.

78
Hardness (PPM, est.)
182
NV Average
136
National Avg
13
Highest PFOA/PFOS (ppt)
0
Lead (ppb)
78 PPM Moderately Hard
CONTAMINANT LEVELS Hardness (est.) 78 PPM TDS (est.) 109 PPM PFOA/PFOS 13 ppt Lead 0 ppb Chlorine (est.) 0.7 mg/L Nitrate 1.45 mg/L
Estimated water hardness gauge for Sparks NV showing 78 PPM Moderately HardWater quality levels in Sparks NV compared to EPA limits - estimated hardness 78 PPM, highest PFOA/PFOS average 13 ppt, lead 0 ppb

Hardness Scale: Where Sparks Falls

Soft
0
Slightly
17
Moderate
60
Hard
120
Very Hard
180
Extreme
250+
PFOA/PFOS above EPA 2029 limit

How Sparks Compares

Sparks's water is 43% softer than the national average of 136 PPM - ranking in the bottom 61% for hardness nationwide. Most homes here do not need a softener. Within Nevada, it ranks #5 of 6 cities (57% below the state average of 182 PPM). Among large cities (200k-500k), Sparks ranks #85 of 136 for hardness.

What Sparks's Water Means for Your Home

Hardness: 78 PPM - Low Concern

Sparks's water is moderately hard at 78 PPM. You'll see some spotting on glassware and a film on shower doors over time, but it's not the kind of hardness that demands a full softener. A salt-free conditioner is worth considering if you have a tankless water heater or high-end fixtures.

Contaminants & Safety

Forever chemicals (PFAS) are a serious concern here. Sparks has PFOA at 5.2 ppt and PFOS at 13 ppt — the EPA's 2024 limit is 4 ppt for PFOA and PFOS individually. PFAS don't break down in your body or the environment. Research links long-term exposure to increased cancer risk, thyroid issues, and immune system problems. The fix: a whole-house activated carbon filter or a point-of-use reverse osmosis system. Look for NSF/ANSI 53 or 58 certification for PFOA/PFOS reduction — that's the certification that specifically tests for PFAS removal.

What's in the Treatment Process

Sparks's surface water supply requires heavy chlorination to stay safe — but that creates a tradeoff. The treatment process generates disinfection byproducts: TTHMs at 26.6 ppb (33% of the legal limit, but 178x the EWG guideline) and HAA5 at 19.7 ppb (33% of the legal limit, but 197x the EWG guideline). These EWG-reported values are below the legal limits, and the EWG sets much tighter thresholds based on cancer-risk research. A whole-house activated carbon filter reduces both chlorine and byproducts.

Chromium-6 was detected at 0.584 ppb, which is 29x the EWG health guideline. There's no separate federal limit for chromium-6, only total chromium. A reverse osmosis system is the most effective removal method. The EWG guidelines represent a more conservative, health-based standard than federal legal limits.

Water quality contaminant levels for Sparks, NV
MeasureResultGuidelineLegal LimitStatus
PFOA (highest entry-point avg.)5.2 ppt0 ppt (EPA goal)4 ppt (from 2029)⚠ Above
PFOS (highest entry-point avg.)13 ppt0 ppt (EPA goal)4 ppt (from 2029)⚠ Above
↳ Total PFAS (average of all samples)2.34 ppt—No total limitDetected
Lead (90th percentile, Dec 2025)0 ppb0 ppb (no safe level)Action level 15 ppb (10 ppb from Nov 2027)✓ Low
Nitrate (EWG data)1.45 mg/L5 mg/L (CheckMyTap flag, half the limit)10 mg/L✓ OK
Hardness (estimate)~78 PPMNot a health issueNo federal limitOK
Total Dissolved Solids (estimate)~109 PPM500 PPM (taste, not enforceable)No federal limitOK
Chlorine / Chloramine (estimate)~0.7 mg/LTaste threshold ~1.04.0 mg/LNormal

Lithium (EPA testing, Jan 2023–Sep 2025)

Average across 142 samples: 2.52 µg/L. Highest single result: 100 µg/L. 6 of 142 samples were above 10 µg/L, EPA's Health Reference Level: a non-regulatory screening value, not a legal limit. Lithium has no federal drinking water limit, and EPA says the health risk at these levels is uncertain. Boiling does not remove it. In EPA's study of treatment plants, reverse osmosis removed more than 90% and ion exchange was inconsistent; we found no home filter certified for lithium reduction. What the lithium results mean

How to Test Your Water in Sparks

With PFAS at 2.34 ppt in Sparks's supply, confirming your home's specific levels is especially important. PFAS vary by neighborhood and can concentrate differently depending on your position in the distribution system.

Most Accurate: Mail-in Lab Test

Mail-in sample analyzed by an accredited lab for metals (including lead), minerals, and more. PFAS needs a separate PFAS test. For PFAS, order a dedicated PFAS lab test.

Tap Score Lab Kit
Quick Check: DIY Test Strips

Results in 60 seconds. Tests hardness, lead, chlorine, pH, and 13 other parameters. Good enough to confirm whether your home matches the city average.

Varify 17-in-1 Test Strips
Verify Your Filter: TDS Meter

Instant digital reading of total dissolved solids. Handy for checking if your filter is performing. Test before and after.

HoneForest TDS Meter

Free option: Request TMWA's annual Consumer Confidence Report for official city-level data.

📊 Already Tested Your Water?

City averages miss neighborhood-level variation. Share your results to help your neighbors get better data.

We review every submission before publishing. Your ZIP is shown; your identity is not.

About Sparks's Water Supply

Water Utility: TMWA

Water Source: Truckee River, groundwater (Surface Water)

Population Served: 442,000

Hardness: 78 PPM (4.6 grains per gallon)

Sparks's drinking water comes from surface sources — Truckee River, groundwater. Surface water requires more extensive treatment than groundwater, including coagulation, filtration, and disinfection. This heavier chlorination is why disinfection byproducts tend to be higher in surface-supplied systems. On the upside, surface sources often deliver softer water than deep aquifers. The system serves 442,000 residents.

Water quality can vary by neighborhood and season. For your exact numbers, request TMWA's Consumer Confidence Report (CCR) or test your own tap.

ZIP Codes In and Near Sparks

This report is for the water system serving Sparks, NV (TMWA). ZIP codes in and near this area:

89310, 89316, 89405, 89406, 89407, 89408, 89412, 89414, 89418, 89419, 89424, 89429, 89431, 89432, 89433, 89434, 89435, 89436, 89437, 89438, 89441, 89442, 89445, 89446, 89496, 89820, 89821

A ZIP code can be served by more than one water system. Confirm your utility on your water bill or your utility's Consumer Confidence Report.

Compare Sparks to Other Nevada Cities

Frequently Asked Questions About Sparks Water

Is Sparks tap water safe to drink?
EPA data shows a health concern for Sparks's water system: PFOA/PFOS above EPA's 4 ppt standard at one or more entry points (PFOA 5.2 ppt, PFOS 13 ppt; EPA UCMR 5 testing, 2023 to 2025; the standard is enforceable from 2029). A filter certified for the specific contaminant (PFAS, lead) reduces what you drink. See the EPA violations section above for dates and status.
Where does Sparks's water come from?
Sparks's drinking water is sourced from Truckee River, groundwater and treated by TMWA. Surface water requires more extensive treatment, including chlorination, which can produce disinfection byproducts.
Do I need a water softener in Sparks?
At 78 PPM, Sparks's water is moderately hard. Some homes notice spotting and reduced soap lathering. Tankless water heater owners should consider at least a salt-free conditioner.
How do I remove PFAS from Sparks tap water?
Sparks has PFAS above EPA limits (PFOA: 5.2 ppt, PFOS: 13 ppt — limit is 4 ppt each). Reverse osmosis and granular activated carbon both reduce PFAS by 95-99%. For most homes, a point-of-use RO system under the kitchen sink is most practical. Look for NSF/ANSI 53 or 58 certification for PFOA/PFOS reduction. Standard pitcher filters do not adequately reduce PFAS.
What water filter is best for Sparks?
The best filter depends on which contaminants you want to address. For PFAS, look for NSF/ANSI 53 or 58 certification for PFOA/PFOS reduction. Granular activated carbon and reverse osmosis are both effective. See our softener vs. filter guide for the full breakdown.
Is Sparks water safe for babies and infants?
Caution is warranted for Sparks water and infant formula. Concerns: PFAS above EPA limits (PFOA: 5.2 ppt, PFOS: 13 ppt). Use filtered water (reverse osmosis or NSF-certified) or bottled water for formula preparation.
What is the hardness of Sparks water in grains per gallon?
Sparks's water hardness is 4.6 grains per gallon (GPG), which equals 78 parts per million (PPM). To convert: 1 GPG = 17.1 PPM.
What are disinfection byproducts in Sparks's water?
Disinfection byproducts form when chlorine reacts with organic matter during water treatment. Sparks has TTHMs at 26.6 ppb and HAA5 at 19.7 ppb (EWG Tap Water Database) — below the legal limits in EWG's data, but above EWG health guidelines. A whole-house activated carbon filter reduces both chlorine and its byproducts.

Data sources: Water system, health-based violations, and lead (90th percentile) from the EPA Safe Drinking Water Information System via ECHO (data as of October 14, 2026). PFAS and lithium from EPA's final UCMR 5 dataset (sampling 2023 to 2025, released August 2026). Disinfection byproducts, chromium-6, nitrate, and other contaminant values and health-guideline comparisons are from the Environmental Working Group (EWG) Tap Water Database (data as of Feb 2026); EWG health guidelines are stricter than legal limits and are not EPA standards. Hardness, TDS, and chlorine are estimates, not utility measurements. Results describe the water system, not your tap: lead in particular depends on your home's plumbing. For your utility's latest results, request its Consumer Confidence Report (CCR). Our methodology · Report a data error. Page data refreshed 2026-11-01.

Common Options for Sparks Homes

Prioritized for contaminant reduction for homes with 78 PPM water and PFAS above EPA limits.

Affiliate disclosure: we may earn a commission. Selection based on Sparks's water data.

On a private well? This report covers Sparks's municipal water only. Interpret your well water lab report

💧 What Does Your Water Need?

Find the right system for Sparks in 60 seconds.

Take the Quiz →

🧪 Test Your Water at Home

City averages may not match your tap. Test for exact numbers.

How to test your water →