Is Milford, CT Tap Water Safe to Drink?
EPA data shows a health concern for Milford's water system. Specifically: PFOA/PFOS above EPA's 4 ppt standard at one or more entry points (PFOA 6.7 ppt, PFOS 9.4 ppt; EPA UCMR 5 testing, 2023 to 2025; the standard is enforceable from 2029). A point-of-use filter certified for the specific contaminant can reduce what you drink while the utility addresses it.
EPA health violations for Regional Water Authority
No health-based violations (exceeding a contaminant or disinfectant limit, or missing a required treatment step) reported to EPA for Regional Water Authority since November 2023.
Source: EPA Safe Drinking Water Information System (SDWIS) via ECHO, data as of October 14, 2026, EPA system ID CT0930011. Covers health-based violations since November 2023; monitoring and reporting violations are not shown. Look up the system on EPA ECHO.

Hardness Scale: Where Milford Falls
0Slightly
17Moderate
60Hard
120Very Hard
180Extreme
250+
How Milford Compares
Milford's water is 79% softer than the national average of 136 PPM - ranking in the bottom 85% for hardness nationwide. Most homes here do not need a softener. Within Connecticut, it ranks #6 of 13 cities (10% below the state average of 31 PPM). Among large cities (200k-500k), Milford ranks #122 of 136 for hardness.
What Milford's Water Means for Your Home
Hardness: 28 PPM - Low Concern
Milford's water is slightly hard at 28 PPM. Most households won't notice any issues at this level. Scale buildup is minimal, and a water softener would be overkill. Milford is softer than 85% of US cities. If you're thinking about water treatment, contaminant filtration is where to focus your money, not softening.
Contaminants & Safety
Forever chemicals (PFAS) are worth watching here. Milford has PFOA at 6.7 ppt and PFOS at 9.4 ppt, exceeding the EPA's 2024 limit of 4 ppt per compound. PFAS are synthetic compounds that accumulate in your body over time. A certified carbon filter or reverse osmosis system certified to NSF/ANSI 53 or 58 for PFOA/PFOS is the most effective protection. See the regulatory timeline.
What's in the Treatment Process
Milford's surface water supply requires heavy chlorination to stay safe — but that creates a tradeoff. The treatment process generates disinfection byproducts: TTHMs at 39.4 ppb (49% of the legal limit, but 263x the EWG guideline) and HAA5 at 31.5 ppb (53% of the legal limit, but 315x the EWG guideline). These EWG-reported values are below the legal limits, and the EWG sets much tighter thresholds based on cancer-risk research. A whole-house activated carbon filter reduces both chlorine and byproducts.
Chromium-6 was detected at 0.237 ppb, which is 12x the EWG health guideline. There's no separate federal limit for chromium-6, only total chromium. A reverse osmosis system is the most effective removal method. The EWG guidelines represent a more conservative, health-based standard than federal legal limits.
| Measure | Result | Guideline | Legal Limit | Status |
|---|---|---|---|---|
| PFOA (highest entry-point avg.) | 6.7 ppt | 0 ppt (EPA goal) | 4 ppt (from 2029) | ⚠ Above |
| PFOS (highest entry-point avg.) | 9.4 ppt | 0 ppt (EPA goal) | 4 ppt (from 2029) | ⚠ Above |
| ↳ Total PFAS (average of all samples) | 2.53 ppt | — | No total limit | Detected |
| Lead (90th percentile, Dec 2026) | 0 ppb | 0 ppb (no safe level) | Action level 15 ppb (10 ppb from Nov 2027) | ✓ Low |
| Nitrate (EWG data) | 0.913 mg/L | 5 mg/L (CheckMyTap flag, half the limit) | 10 mg/L | ✓ OK |
| Hardness (estimate) | ~28 PPM | Not a health issue | No federal limit | OK |
| Total Dissolved Solids (estimate) | ~48 PPM | 500 PPM (taste, not enforceable) | No federal limit | OK |
| Chlorine / Chloramine (estimate) | ~1.4 mg/L | Taste threshold ~1.0 | 4.0 mg/L | Normal |
Lithium (EPA testing, Sep 2023–Jun 2024)
Average across 30 samples: 0 µg/L. Highest single result: 0 µg/L. 0 of 30 samples were above 10 µg/L, EPA's Health Reference Level: a non-regulatory screening value, not a legal limit. Lithium has no federal drinking water limit, and EPA says the health risk at these levels is uncertain. Boiling does not remove it. In EPA's study of treatment plants, reverse osmosis removed more than 90% and ion exchange was inconsistent; we found no home filter certified for lithium reduction. What the lithium results mean
Recommended Filter for Milford
PFAS exceed EPA limits (PFOA: 6.7 ppt, PFOS: 9.4 ppt — limit: 4 ppt each). A certified filter reduces these contaminants effectively.
See all filter recommendations for MilfordQuick Fix for Chlorine: Shower Filter
At 1.4 mg/L chlorine, many Milford residents notice dry skin, brittle hair, and that "pool smell" in the shower. A shower filter installs in 5 minutes, no tools needed.
How to Test Your Water in Milford
With PFAS at 2.53 ppt in Milford's supply, confirming your home's specific levels is especially important. PFAS vary by neighborhood and can concentrate differently depending on your position in the distribution system.
Free option: Request Aquarion Water Company's annual Consumer Confidence Report for official city-level data.
📊 Already Tested Your Water?
City averages miss neighborhood-level variation. Share your results to help your neighbors get better data.
We review every submission before publishing. Your ZIP is shown; your identity is not.
About Milford's Water Supply
Water Utility: Aquarion Water Company
Water Source: Housatonic River & wells (Surface Water)
Population Served: 418,900
Hardness: 28 PPM (1.6 grains per gallon)
Milford's drinking water comes from surface sources — Housatonic River & wells. Surface water requires more extensive treatment than groundwater, including coagulation, filtration, and disinfection. This heavier chlorination is why disinfection byproducts tend to be higher in surface-supplied systems. On the upside, surface sources often deliver softer water than deep aquifers. The system serves 419,000 residents.
Water quality can vary by neighborhood and season. For your exact numbers, request Aquarion Water Company's Consumer Confidence Report (CCR) or test your own tap.
ZIP Codes In and Near Milford
This report is for the water system serving Milford, CT (Aquarion Water Company). ZIP codes in and near this area:
06418, 06460, 06461, 06477, 06484, 06491, 06614
A ZIP code can be served by more than one water system. Confirm your utility on your water bill or your utility's Consumer Confidence Report.
Compare Milford to Other Connecticut Cities
Frequently Asked Questions About Milford Water
Is Milford tap water safe to drink?
Where does Milford's water come from?
Do I need a water softener in Milford?
How do I remove PFAS from Milford tap water?
What water filter is best for Milford?
Is Milford water safe for babies and infants?
What are disinfection byproducts in Milford's water?
Is chromium-6 in Milford's water?
Data sources: Water system, health-based violations, and lead (90th percentile) from the EPA Safe Drinking Water Information System via ECHO (data as of October 14, 2026). PFAS and lithium from EPA's final UCMR 5 dataset (sampling 2023 to 2025, released August 2026). Disinfection byproducts, chromium-6, nitrate, and other contaminant values and health-guideline comparisons are from the Environmental Working Group (EWG) Tap Water Database (data as of Feb 2026); EWG health guidelines are stricter than legal limits and are not EPA standards. Hardness, TDS, and chlorine are estimates, not utility measurements. Results describe the water system, not your tap: lead in particular depends on your home's plumbing. For your utility's latest results, request its Consumer Confidence Report (CCR). Our methodology · Report a data error. Page data refreshed 2026-11-01.
Common Options for Milford Homes
Prioritized for contaminant reduction for homes with 28 PPM water and PFAS above EPA limits.
Affiliate disclosure: we may earn a commission. Selection based on Milford's water data.